Adt-security-services Safewatch Plus Enterpreneur Security Systems Manuel d'utilisateur Page 1

ADT-1090-INT 7/25/00 3:12 PM Page 1

SPECIAL FEATURESThe CHIME mode allows audible monitoring of zones while the system isdisarmed. When the CHIME mode is active, the control station soun

The bypass key (#) is used to bypass selected zones in your system. A bypassed zonewill NOT be capable of activating an alarm as it is temporarily rem

Your system may utilize a conventional key switch for arming and disarming thesystem. Arming and disarming with a key switch is performed as follows:c

ProgrammingCertain features of your system are programmable through the control station. Theprogramming mode is entered by pressing key 9 and holding

Determine your desired new User Code or Master User Code sequence. If youmake an error while programming, press the“ * ” key five times and start over

An optional feature of your system allows you to assign a certain number of validuses to User Code 6. After the code has been used the programmed amou

Notes

The TEST mode commands the control station to beep continuously and light thecorresponding zone indicator, each time a zone is violated. The zone indi

FIRE DETECTIONYour system may or may not include fire detection, depending upon what optionswere purchased, and the local codes and regulations for yo

Emergency Evacuation PlanPreparation and education are of prime importance in the prevention of fire. Anemergency evacuation plan should be establishe

ADT-1090-INT 7/25/00 3:12 PM Page 2

The purpose of heat and smoke detectors is to detect a fire in its earliest stages andsound an alarm, giving occupants more time to exit the premises

0 Smoke Detector LocationSmoke detectors should be installed in accordance with theNational FireProtectionAssociation (NFPA) Standard 74.The followin

Smoke Detector Placement4 inches@lm) -_INOTE: Allmae~~mmennts are tothe closest edge of the dote&orA Smoke Detector shouldbe located on each story

GlossaryAlarm Memory: A history of the alarm that last occurred.Arm: To turn the intrusion detection system on.Bypass: To temporarily remove a zone fr

ADT-1090-INT 7/25/00 3:13 PM Page 12

ADT-1090-INT 7/25/00 3:13 PM Page 12

Notes20

FCC COMPLIANCEThis equipment ganerates and uses radio frequency energy and lf nU installed and used properly, that !a. In strictaccordance with the rt

MOOSESentrol, Inc resen~es the rtghtto change specifmtmnswthout noticetJ1991 Sentrol. Inc

Table of Contents*System Reference...2Operating Your System...3ARM

Zone Identification CardSpace is provided forrecording the areas ofprotection which are;“““““““““‘““““““““’: lndlvldual Zone StatusiReady statusIf lig

Operating Your SystemARMINGBefore the control can be armed, all of the intrusion zones must be secure asindicated by the green READY indicator. If the

;I Turning Off the lnterlor Zones and Entrance DelayControl station key 4 may be used to turn the interior zones off prior to arming. Thiswill allow t

DISARMINGYour system is programmed with one or more entrance delay zones which allowtime to enter the premises without causing an alarm. Each delay do

ALARM CONDITIONSWhenever an alarm occurs, the ALARM indicator will light, the audible alarm willsound (if applicable), and the control wilI communicat

THE EMERGENCY KEYPAD PANIC ALARMSYour system may have been purchased with up to three emergency keypad panicalarms. These may be used to activate an a